AquaBen SoilFloc Pond Sealant

Polymer Pond Sealant – Apply Through-the-water Soilfloc is a polymer based soil sealant that can be applied through the water column to seal soil seepage without draining the pond or reservoir. It is non-toxic, biodegradable, and has been tested for impacts to aquatic organisms in major University Studies. It can also be applied during construction to improve the soil’s sealing capability. This is by far the most cost effective method to attempt to seal a pond without completely draining the water. – Soilfloc works best in ponds and reservoirs with widespread seepage or with significant localized leaks. The polymer works by swelling in soil pores and attracting fine clay particles to further clog the soil. For larger leaks, pond dye can be an effective tool to observe sub-surface currents and identify the leak area. – The 2-Part polymer based sealant is supplied in a fine granular form. Each unit includes 55 pounds of Part A and 55 pounds of Part B. Each 110 pound unit treats approximately 3,000 square feet of pond bottom. Heavier application rates may improve effectiveness. – Soilfloc Sealant is the best polymer based sealant available for your canal, irrigation ditch or pond. Specifically designed to find leaks, whether in the floor, the wall or through rock formations and seal them. Soilfloc contains linear and cross-linked polymers to seal any type of soil, for any sized project. From small earth-bottom Koi ponds to large ponds and lakes, it is an extremely cost effective solution to your water loss problems. – Soilfloc Sealant is the product of choice for sealing leaks without dewatering ponds, reservoirs, irrigation ditches, watering holes, golf course water hazards, and residential ponds. – Easy to use – Cost effective – Long lasting – No need to drain water – Material is drawn to leaks and seals – Non-toxic, biodegradable, environmentally friendly – Will not harm livestock – If your pond / lake / reservoir has water in it & is currently leaking, now is the best time to apply. The flow toward the leak, draws the polymers into the problem areas to seal the leaks. – Do not under apply! Not recommended for application to water bodies less than 10,000 square feet in size. – Prepping for Application – Remove any deep silt, livestock, dense reeds or heavy vegetation, as they can impede the polymers ability to get to the seepage. – Simply sprinkle Part A and Part B over the surface of the water. The water should not be moving and you should not apply during rain or wind events. Distribute it as if you are feeding chickens at the recommended rates. Remember to cast out gently no more than 5 by hand, scoop or fertilizer spreader from a boat or raft. – Apply minimum of:4 oz. per 10 sq. ft. applied as follows – Soilfloc Sealant Part A 2 oz. per 10 sq. ft. – Soilfloc Sealant Part B 2 oz. per 10 sq. ft. – Apply Soilfloc Sealant Part A to approx. 10 sq. ft. section first followed immediately by Part B to the same 10 sq. ft. before moving to the next section. – What is Soilfloc Sealant Soilfloc Sealant is a polymer based, Earthen Pond Sealant. Polymers make up many of the materials in living organisms, including proteins; they are natural or